AC repair
Furnace & heating
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateStyles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
See the difference
Before
After
Before
After
Before
AfterHow Much Does AC Installation Cost in Burbank?
AC installation in Burbank typically costs $3,500 to $7,500 for a complete new system, including equipment and labor. Most single-family homes land between $4,200 and $6,000 once the tonnage, duct condition, and electrical work are measured. The written estimate sets the final price, and we provide that estimate free.
That range covers what most Burbank homeowners actually need: a matched condenser and air handler, new line set where required, refrigerant charge, and a startup check. It doesn’t cover duct replacement, which is a separate scope, and we’ll tell you plainly when your existing ducts are fine.
Key Takeaways
- A full AC installation in Burbank runs $3,500 to $7,500, with the written estimate setting the final figure.
- Our technicians have up to experience and are factory-familiar with 9 major brands, including Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard.
- Burbank’s inland valley heat drives long cooling hours in July and August, so correct sizing matters more here than in milder parts of Los Angeles County.
- An AC repair in Burbank runs $150 to $650, and sometimes that’s the smarter spend than a full replacement.
- Estimates are free. Call (844) 962-2046. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
AC Installation Cost Breakdown (2026)
Here’s how a typical Burbank installation breaks down. These are estimated ranges for planning purposes, not a quote. Every home gets its own written estimate.
| Line item | Typical estimated range |
|---|---|
| Complete AC installation (equipment + labor) | $3,500 – $7,500 |
| Standard single-stage system, straightforward swap | $3,500 – $4,800 |
| Two-stage or variable-speed system | $5,200 – $7,500 |
| AC repair (for comparison) | $150 – $650 |
| Furnace repair (for comparison) | $150 – $700 |
| Seasonal tune-up | $80 – $200 |
What pushes a job toward the top of that range? Higher-efficiency two-stage and variable-speed equipment, a system that needs a new line set because the old one won’t support the refrigerant the new unit uses, and electrical work at the panel or disconnect. What keeps it lower? A like-for-like replacement of the same tonnage in the same location, with existing ducts and wiring that pass inspection.
We work on the system you already have, and that extends to replacement. If your home has a Carrier, Trane, or Lennox system now, we’re not going to steer you toward a different brand for our own convenience. We’ll give you options across the brands we know and let you decide.
What Affects AC Installation Pricing in Burbank
Burbank sits in the eastern San Fernando Valley, where summer afternoons routinely climb into the upper 90s and the heat lingers into the evening. That climate shapes installation decisions in ways a coastal city’s market doesn’t.
- System size and tonnage. A 1,200-square-foot bungalow near Magnolia Park needs a smaller system than a 2,400-square-foot house up in the hills above Sunset Canyon. Correct sizing uses a load calculation, not a guess based on square footage alone. An oversized unit short-cycles, and that costs you more over its life than the right size costs up front.
- Equipment tier. Single-stage equipment is the budget option. Two-stage and variable-speed systems cost more but run quieter and hold a steadier temperature through Burbank’s long cooling season. The gap between tiers is roughly $1,500 to $2,500 on a typical job.
- Duct condition. Older Burbank homes, especially those built in the postwar decades around downtown and the Rancho district, often have ductwork sized for a system that’s long gone. If the ducts can’t handle the new unit’s airflow, you’ll either replace them or accept reduced performance. We check this before quoting, not after.
- Electrical and panel capacity. A new condenser draws more current than a 1990s unit. If your panel is full or the disconnect is undersized, an electrician’s work gets added to the scope. This is common in older homes and it’s one of the biggest swing factors in the final price.
- Location and access. A condenser on a ground pad with clear access is a straightforward install. A unit on a rooftop, in a tight side yard, or behind a fence that has to come down adds labor hours. Hillside properties with limited equipment access cost more to work on.
- Refrigerant transition. Systems using older refrigerant can’t simply be recharged with the newer blends. If your existing line set isn’t compatible with the new equipment, it gets replaced. That’s a real line item, not an upsell.
Repair or Replace? How to Decide
Replacement makes sense when the repair cost approaches a third of a new system’s price and the equipment is already past its expected service life. Below that, repair usually wins.
Here’s the honest math for Burbank. An AC repair runs $150 to $650. A new installation runs $3,500 to $7,500. If your system is twelve years old and needs a $500 repair, you’re putting money into equipment that may have another three or four seasons in it. If it’s six years old and needs the same repair, fix it and keep going.
We’ll tell you which one actually makes sense for your situation. That’s the whole conversation. Fast diagnosis, honest options, and no pressure to replace a system that still has life in it. If you want the full picture on what a replacement involves, our AC installation page walks through the process step by step.
How Long Does Installation Take?
A standard residential AC installation in Burbank takes one full day for a like-for-like replacement. Jobs that include duct modifications, electrical upgrades, or a change in equipment location can take two days.
Here’s how the day usually goes. The crew arrives in the morning, protects the floors and work areas, and recovers the refrigerant from the old system. The old equipment comes out. The new condenser goes on the pad and the air handler goes in the closet or attic. Line set, electrical connections, and the thermostat follow. Then the system gets charged, started, and tested through a full cooling cycle before anyone leaves.
You’ll want the area around the indoor unit and the outdoor pad clear before the crew arrives. That’s the main thing a homeowner can do to keep the day moving.
Can You Install a New AC the Same Day?
Same-day installation is possible when the equipment is on hand and the job is a straightforward replacement, but most installations are scheduled. We confirm the date and window with you when you book.
If your system has failed and you’re without cooling, call us. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening. We’re closed Saturday.
How to Save on AC Installation
The biggest savings on a Burbank AC installation come from avoiding scope creep, not from chasing a lower equipment price.
- Get the load calculation done properly. A correctly sized system costs less to buy and less to run. Oversizing is the most common and most expensive mistake we see.
- Keep your existing ducts if they’re sound. A duct inspection costs far less than a duct replacement. If your ducts are sealed and sized right, leave them alone.
- Compare equipment tiers honestly. A two-stage system costs more up front but may suit a home with rooms that run hot and cold. A single-stage unit is fine for a well-insulated house with balanced airflow. We’ll tell you which fits yours.
- Handle the electrical scope early. If you know your panel is full, get that sorted before installation day. Surprises mid-job cost more than planned work.
- Ask about the full lifecycle. A well-maintained system lasts longer. Our tune-up service runs $80 to $200, and keeping up with it protects the investment you just made.
Estimates are free, and we’ll walk you through the numbers before you commit to anything. Call (844) 962-2046.
What Brands Do We Install and Service?
We’re factory-familiar with 9 of the industry’s leading HVAC brands: Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. That means our technicians aren’t learning on the job with unfamiliar equipment.
If your home already has one of these systems, you’ll get someone who knows the specific equipment. And because we’re brand-agnostic, we’re not going to push you toward a particular manufacturer because of a dealer arrangement. We’ll lay out the options and let you choose.
Heating and cooling is the only trade we perform. We don’t do plumbing, electrical, or roofing, and we don’t hand your project to a generalist. If your AC needs work, that’s what we do. If your furnace needs repair or replacement, that’s also us. One point of contact for the whole system.
For a broader look at what we handle, visit AC Repair Burbank.
Why Burbank Homeowners Choose Us
Three things matter when you’re hiring someone to install a system you’ll live with for the next fifteen years: whether they know your equipment, whether they’ll give you a straight answer, and whether they’ll show up when they said they would.
We’re a dedicated HVAC company, not a multi-trade operation. Our technicians have up to experience, and every hour of their training goes toward heating and cooling. We’re licensed and insured. We work on the brands already in your home, and we cover the full equipment lifecycle, from new installation to repair as the system ages.
If you’re wondering whether to repair or replace, we’ll tell you which one makes sense. If a repair will get you another five years, we’ll say so. That’s how we’d want to be treated.
FAQs – AC Installation Cost
How much does AC installation cost in Burbank?
AC installation in Burbank typically costs $3,500 to $7,500 for a complete system. Most single-family homes fall between $4,200 and $6,000. The written estimate sets the final price. Call (844) 962-2046 for a free estimate.
Is it cheaper to repair or replace my AC?
Repair is usually cheaper when the repair runs $150 to $650 and the system still has years of service left. Replacement at $3,500 to $7,500 makes more sense when the repair approaches a third of that figure and the equipment is already old. We’ll evaluate both and tell you which one actually makes sense. Call (844) 962-2046.
Why is AC installation more expensive in some Burbank homes than others?
The price difference usually comes from three things: system size, duct condition, and electrical work. A straightforward replacement in a home with sound ducts and a modern panel lands near $3,500 to $4,800, while a job needing a new line set, duct modifications, or a panel upgrade climbs toward $7,500. The estimate is free, so call and we’ll give you a real number.
How much does a new AC unit cost without installation?
Equipment alone typically accounts for the larger share of a $3,500 to $7,500 installation, but we don’t quote equipment separately because the price depends on sizing, refrigerant, and the rest of the system. You get one written estimate for the whole job. Call (844) 962-2046 for yours.
Do you install AC the same day?
Same-day installation is possible when the equipment is on hand and the job is a straightforward replacement, but most installations are scheduled. We confirm the date when you book. Call (844) 962-2046. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Get a Free AC Installation Estimate in Burbank
If your system is on its last summer or you’re planning ahead for a replacement, we’ll come out, measure the house, check the ducts and electrical, and give you a written estimate at no cost. No pressure, no brand pitch, just the numbers and an honest read on whether you need a new system or a repair that’ll keep the old one going.
Call (844) 962-2046. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. We’re closed Saturday. Estimates are free, and the written estimate sets the final price.
Pricing reflects the Burbank market as of 2026. AC Repair Burbank offers free estimates – call (844) 962-2046.
Written by the team at AC Repair Burbank.
What Our Customers Say
"Got a text with the technician's name and photo before he arrived. Small thing, but as a woman home alone during the day I actually really appreciated it."
- Alma Martinez"Contactor was pitted and chattering. Cheap part, quick fix, and he showed me the burn on the old one so I could see for myself."
- Javier Morales"New system install, two days, and they were careful with the floors and the attic access the entire time. Registered the warranty for me and emailed the paperwork."
- Daniel Lawson