Furnace Replacement in Burbank, CA | AC Repair Burbank

Furnace Replacement in Burbank - Load-Calculated, Priced in Writing

We size the system with a proper load calculation rather than copying what was there, then give a written fixed price with the install date set. Rebate and financing paperwork handled for you.

Call to schedule your free estimate

Work is performed by our local vetted partner.

Free
Written Quotes
Licensed & Insured Written Quotes Free Estimates All Brands Satisfaction Guarantee

Work is performed by our local vetted partner.

AC repairAC repair
Furnace & heatingFurnace & heating
Heat pumpsHeat pumps
Ductless mini splitsDuctless mini splits
CarrierCarrier
TraneTrane
GoodmanGoodman
Every visit starts with

Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed

We have financing partners for your new heating and cooling system

Diagnosis first, numbers second - you approve the repair price before a single part goes in.

Get your free estimate
Questions about your HVAC?Free estimate, price agreed before work starts
Call (844) 962-2046

Trusted Furnace Replacement for Burbank Homeowners

When a furnace starts failing in December, the problem isn’t just discomfort. In Burbank‘s older single-family homes and post-war apartment conversions, a dying furnace often means a scramble to find someone who knows the equipment already bolted to your closet floor or garage wall. We specialize in furnace replacement, which means we’re not splitting our attention across plumbing or roofing. Our technicians have up to 8 years of experience, and we’re factory-familiar with 9 leading brands, so we know the failure points on the Trane or Lennox unit you’re staring at right now. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Call (844) 962-2046 and we’ll give you a straight answer on repair versus replacement.

Call (844) 962-2046

What Our Furnace Replacement Service Includes

Full Heating System Assessment

Before we quote a replacement, we run a full assessment of your existing system: the furnace itself, the ductwork feeding each room, the thermostat wiring, and the electrical or gas connections. This matters because a furnace that’s “failed” sometimes has a duct problem or a thermostat fault masquerading as a dead heat exchanger. We give you the diagnosis first, then tell you honestly whether a repair buys you another few seasons or whether replacement is the smarter money. If a repair makes sense, we’ll say so.

Full Heating System Assessment

System Sizing and Load Calculation

Replacing a furnace with the same size unit isn’t always right, especially in Burbank homes where additions, window upgrades or attic conversions have changed the heating load since the original install. We calculate the proper capacity for your home’s square footage, insulation, window area, and duct layout rather than guessing from the old nameplate. An oversized furnace short-cycles, wastes gas, and wears out faster; an undersized one never keeps up on the coldest mornings. Getting this right is the single biggest factor in how the next 15 years go.

System Sizing and Load Calculation

Removal and Safe Disposal of the Old Unit

Pulling out a furnace means disconnecting gas lines, electrical feeds, and the flue or venting, then hauling a heavy unit out of a tight closet or attic access without damaging walls or ductwork. We handle the disconnection, removal, and proper disposal of the old equipment. If your old unit contains components that require special handling, we take care of that too, so you’re not stuck figuring out what to do with a 150-pound appliance in your garage.

Removal and Safe Disposal of the Old Unit

New Furnace Installation and Commissioning

Installation covers setting the new unit, connecting gas and electrical, sealing the plenum and duct connections, and installing or adapting the venting to match the new furnace’s requirements. We then commission the system: checking gas pressure, verifying airflow, testing the thermostat through a full heat cycle, and confirming the safety switches work. You get a walkthrough of the new equipment and the controls before we leave. Our work spans the full equipment lifecycle, so when this furnace eventually needs a repair, you’re calling the same people who installed it.

Post-Install Verification and Documentation

After the install, we document what was done: the model and serial number of the new unit, the settings we used, and any duct or venting changes. That record matters when you sell the home or file a warranty claim. We also walk you through filter location, filter size, and how often to change it in Burbank’s dusty spring air, since a clogged filter is the most common reason a new furnace underperforms in its first year.

Need help today?Fast, friendly service and a no-obligation free estimate.

Call (844) 962-2046

Explore

Styles & brands we work with

  • AC repair
  • Furnace & heating
  • Heat pumps
  • Ductless mini splits
  • Carrier
  • Trane
  • Goodman

Brands We Service for Furnace Replacement

We work on the system you already have, and that includes the major brands most Burbank homes were built or retrofitted with. Trane equipment tends to be robust but has specific control board and inducer motor behavior we’ve learned to read quickly during diagnosis. Lennox furnaces show up frequently in this area, and we know where their heat exchangers and pressure switches tend to fail as they age. Goodman units are common in value-focused installations, and we know their airflow characteristics and common ignition faults well enough to skip the guesswork.

Rheem furnaces turn up in a lot of the older housing stock around Burbank, and their venting and gas valve configurations reward someone who’s worked on them before. We’re also familiar with Carrier, York, Daikin, Bryant, and American Standard equipment, so whether you have a Rheem or any other make, we can help. We’re not a dealer pushing one line. We replace what’s there with something that fits your home and your budget, and we tell you when a brand you already trust is the right call.

Signs You Need Furnace Replacement Right Now

  • The furnace is 15 years old or older and repairs are stacking up. A furnace past its expected service life can still run, but each repair costs more than the last and the efficiency losses quietly eat your gas bill. When you’re calling for a fix every season, replacement usually costs less over the next five years than keeping the old unit alive.
  • You smell gas or notice soot or corrosion around the unit. A gas smell, yellow instead of blue flame, or soot streaks near the furnace point to a combustion or venting problem that needs immediate professional attention. Don’t run the system while you wait; shut it off at the thermostat and call a trained technician. This is a safety issue, not a maintenance item.
  • The heat never reaches the far rooms, or the house feels cold even with the furnace running. This can be a sizing problem, a duct problem, or a blower on its way out. If you’ve already tried balancing the vents and it hasn’t helped, a proper assessment tells you whether the furnace itself is the culprit.
  • Your gas bills jumped and the house isn’t any warmer. A furnace loses efficiency as its heat exchanger degrades and its burners foul. If you’re paying more for the same comfort, the unit is telling you something.
  • The furnace short-cycles, bangs, or shuts off before reaching temperature. Repeated short cycling stresses every component and often signals a failing limit switch or a blocked flue. It’s also a sign the unit may be oversized for the ductwork, which a replacement with proper sizing can solve.

Our Furnace Replacement Process – Step by Step

  1. 1
    Diagnostic visit and honest recommendation. We inspect the furnace, test the ignition sequence, check gas pressure, and look at the heat exchanger and venting. We also look at your ductwork and thermostat. Then we tell you plainly whether a repair makes sense or whether replacement is the better move, with the reasoning behind it.
  2. 2
    Load calculation and written fixed-price quote. We measure your home and calculate the heating capacity it actually needs, then put a fixed price in writing before any work starts. The quote covers the equipment, labor, removal and disposal of the old unit, and any venting or duct adaptation required.
  3. 3
    Equipment selection and scheduling. We walk you through unit options that fit your home, your budget, and the fuel type you already have, and you pick. Then we set an installation date that works for you. This is scheduled work, not same-day work, because the unit has to be ordered and the install has to be done right.
  4. 4
    Installation day. We protect the work area, disconnect and remove the old furnace, set and connect the new unit, seal the duct connections, and verify the venting. We test gas pressure and airflow, then run the system through a complete heat cycle to confirm it’s operating safely and to spec.
  5. 5
    Walkthrough and handoff. We show you the new equipment, the controls, and the filter location, and we leave you with the documentation on what was installed. If you have questions about the system a month later, call us. We answer 24/7.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade
Want to talk it through?Free estimate, price agreed before work starts
Call (844) 962-2046

How Much Does Furnace Replacement Cost in Burbank?

Furnace replacement in Burbank typically falls in the same range as our AC installation work, roughly $3,500 – $7,500 depending on the equipment and the complexity of the install. A straightforward swap in a standard closet with matching ductwork sits near the low end. Higher-efficiency equipment, a harder location like a tight attic, new venting, or duct modifications push toward the upper end. If your furnace only needs a repair rather than replacement, that’s a separate job and typically runs $150 – $700 for furnace repair in Burbank.

What affects the price most: the efficiency rating and brand of the new unit, whether the venting needs to be changed, whether the electrical feed needs an upgrade, and whether the ductwork needs sealing or modification. You avoid overpaying by getting a written fixed price before work begins and by asking whether the quote includes removal and disposal of the old unit; ours does. Our free estimate includes a load calculation, a walkthrough of the unit options, and a written price that doesn’t change unless you change the scope. The written estimate sets the final price.

Furnace Replacement Near Burbank – Our Service Area

We work throughout Burbank and the surrounding neighborhoods, including Magnolia Park, Toluca Lake, and the Rancho Adjacent area, plus nearby cities like San Fernando, Glendale, and North Hollywood. We also serve Beverly Hills and the Westside for scheduled installations. Furnace replacement is planned work, so we schedule the install date with you and confirm the window in advance. For breakdowns, fast dispatch from 7am to 7pm gets a technician to you quickly, and our AC Repair Burbank team handles AC installation and furnace repair as well.

Serving Burbank, CA – Our Local Coverage Area

We serve Burbank and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.

Frequently Asked Questions – Furnace Replacement in Burbank

Schedule Your Furnace Replacement Service in Burbank Today

If your furnace is on its last legs, don’t wait for the coldest week of the year to deal with it. Call (844) 962-2046 for a free estimate and a straight answer on repair versus replacement. We work on the system you already have, we’re familiar with the major brands, and our estimates include a load calculation and a written fixed price. We answer 24/7, and for breakdowns, fast dispatch from 7am to 7pm, Sunday through Friday. Remember, we also handle furnace repair when a fix is the better move.

Written by the team at AC Repair Burbank.

Why Burbank Chooses AC Repair Burbank

We set the standard for furnace replacement in Burbank.

30-60 Min Response

Fast dispatch across Burbank, 7am-7pm. Same-day service available.

Licensed & Insured

Fully certified technicians who meet all local and state licensing requirements.

Upfront Pricing

No hidden fees, no surprises. You approve the price before any work begins.

Guaranteed Work

Every repair and installation is backed by our workmanship warranty and satisfaction guarantee.

How It Works in Burbank

Getting your furnace replacement handled is simple and fast.

1

Call or Request a Free Estimate

Tell us about your furnace replacement needs and we provide an upfront, transparent quote with no obligation and no hidden fees.

2

Licensed Technician Dispatched

A background-checked, certified technician arrives in Burbank - typically within 30-60 minutes.

3

Problem Solved, Guaranteed

We complete the job to your full satisfaction, backed by our warranty and satisfaction guarantee.

What happens when you call

  1. 1
    A real person answersNo phone trees. Talk to a local furnace replacement pro.
  2. 2
    You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
  3. 3
    A background-checked tech heads outLicensed & insured, typically within the hour.
  4. 4
    You approve before work beginsNothing starts until you say go.

What Burbank Customers Say

Trusted by homeowners across Burbank and surrounding areas.

★★★★★

"Got a text with the technician's name and photo before he arrived. Small thing, but as a woman home alone during the day I actually really appreciated it."

Alma Martinez
★★★★★

"Contactor was pitted and chattering. Cheap part, quick fix, and he showed me the burn on the old one so I could see for myself."

Javier Morales
★★★★★

"New system install, two days, and they were careful with the floors and the attic access the entire time. Registered the warranty for me and emailed the paperwork."

Daniel Lawson

Ready for Furnace Replacement in Burbank?

Call now for a free estimate, or request one below. Licensed, insured, and here with fast help in Burbank.

(844) 962-2046

Request a Free Estimate in Burbank

Tell us about your furnace replacement needs. We'll respond within the hour.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Local Service Coverage
Call Now - We Answer 24/7